First Object Produced on a 3D Printer During Earth Orbit

 
 
By Todd R. Weiss  |  Posted 2014-11-28 Print this article Print
 
 
 
 
 
 
 
3D printing on ISS

The part, a faceplate for the printer itself, was produced on the 3D printer that is now aboard the International Space Station. The project is just the start for more plans to print things in space.

For the first time, astronauts on the International Space Station (ISS) used a 3D printer to manufacture a part in zero gravity while orbiting the Earth. The experiment is a milestone because it proves that 3D printing is viable in space, adding flexibility for future missions that might require spare parts that no one had bothered to bring from Earth.

The first 3D-printed part on the ISS was produced after commands were sent up to the printer by NASA engineers on Nov. 24, according to the space agency. The first part, a faceplate for a component of the printer called the extruder, was "printed" through a process called additive manufacturing, which heats a relatively low-temperature plastic filament and pushes it out, or extrudes it, one layer at a time, to build the part in 3D form, according to NASA.

The successful use of the printer and the good quality of the finished extruder faceplate "demonstrated that the printer can make replacement parts for itself," NASA stated.

That capability is huge for the space agency and future missions, particularly those that would go farther into space than humans have ever traveled before, such as Mars. The farther a mission travels, the more vehicle weight can be an engineering challenge, making it tougher to carry lots of spare parts. If a 3D printer could be counted on to print needed parts in space on such missions, it could lessen such weight and bulk challenges, according to NASA.

"This first print is the initial step toward providing an on-demand machine-shop capability away from Earth," Niki Werkheiser, project manager for the ISS 3D Printer at NASA's Marshall Space Flight Center in Huntsville, Ala., said in a statement. "The space station is the only laboratory where we can fully test this technology in space."

The 3D printer, which was designed and built by Made In Space, a partnership between the Marshall Space Flight Center and other organizations for NASA, arrived at the ISS in September as part of a resupply mission. It was formally installed on Nov. 17 by NASA astronaut Barry "Butch" Wilmore, the commander of the ISS Expedition 42 mission, and underwent tests and calibration before being used to print the first part, according to NASA. The tests were completed Nov. 20.

When Wilmore removed the part from the printer and inspected it on Nov. 25, he found that it had adhered more firmly than anticipated to the tray in which it was printed, according to NASA. That "could mean layer bonding is different in microgravity, a question the team will investigate as future parts are printed," said NASA.

He then installed a new printer tray in anticipation of the next experiment with the printer. "The ground team makes precise adjustments before every print, and the results from this first print are contributing to a better understanding about the parameters to use when 3D printing on the space station," according to the agency.

"This is the first time we've ever used a 3D printer in space, and we are learning, even from these initial operations," NASA's Werkheiser said.



 
 
 
 
 
 
 
 
 
 
 
 
 

Submit a Comment

Loading Comments...
 
Manage your Newsletters: Login   Register My Newsletters























 
 
 
 
 
 
 
 
 
 
 
Rocket Fuel